Command strip mounted wall mount for the Backbone controller. Works with both the V1 and V2 controller (USB-C or Lightning) and fits in between all the standard adapters that might be installed in the controller. Provides enough distance from the wall so the controller doesn't hit it. Slides in very nice and snug. Print sideways, so its all just one profile all the way up. No supports necessary.

Backbone Controller Wall Mount

BackboneWallMount.obj

This is a box that will take 4x Banana Jacks, to be wired together with thick gauge tinned bus wire, and then ran out the box via a (also adequately thick gauge) cable which can be attached to a ground point, either via a wall outlet or metal piping.

Notice: I am not a professional electrician or EE, just a hobbyist. By no means do I condone the use of this device anywhere near line voltage, or with anything that could conceivably be considered "high voltage" in any regard. Use yr noggins!

V1 doesn't have a hole for the cable (my mistake, but might be helpful to someone)

Grounding Box (Banana Jack)

GroundboxV2

Mounted on any corner of any cabinet, this piece provides a place for a magnet to hold the cabinet shut. I measured the hole on the model and it appears to be 18x5, although the magnet I used measures closer to 17.9x4.9. It was a circular black style one, not neodymium, although I'm sure you could find one in the right size if you wanted to make it stronger.

Cabinet Corner Magnet Mount

Activity related to collaborating with others on models

Likes, comments, and activity from your community

A roundup of models that we think you'll like

For when we think someone might have posted your content as their own

New content from your premium memberships

Emails and messages from designers you follow

thebenepstein

Backbone Controller Wall Mount

Grounding Box (Banana Jack)

Cabinet Corner Magnet Mount