2D3D
Makes
This model is restricted by licensing terms.
View license.
148 Likes469 DownloadsApril 19, 2024
This model is restricted by licensing terms.
View license.
Please read pdf for full instruction.
This dragon is very easy to print. In my opinion best size is 120%. I printed with bambulab at a high quality setting and a 0.16 layer. I use the brim for safety, but in the large version it may not be necessary. Good calibration and retraction is necessary for a great result.
For personal use only All my files are protected by Copyright, should NEVER be shared, resold or remixed. To legally sell physical print of my design visit: www.bottega3d.com or subscribe a commercial level
Settings: NOZZLE: 0,4 mm. LAYER: 0.16 – 0.20 OUTER WALLS: 3 INFILL: 10% SUPPORTS: NO Z-HOP: 0.8 BRIM: If necessary
Categories:
148 Likes469 DownloadsApril 19, 2024
This model is restricted by licensing terms.
View license.
148 Likes469 DownloadsApril 19, 2024
This model is restricted by licensing terms.
View license.